Setting the flash to fire for each shot (On) (PowerShot ELPH 350 HS / IXUS 275 HS)
Solution
When setting [Flash] to [Auto], [Flash] is not activated if the surroundings are light. However, when shooting with the subject backlit, [Flash] is sometimes used not to make the subject dark. This section describes the setting to shoot the shots with constant flash.
IMPORTANT
- The following section explains the setting procedures when the camera’s shooting mode has been set to [Program AE] (
). - The flash cannot be set to [On] in some shooting modes. The shooting modes in which the flash cannot be set to [On] are shown below:
[Hybrid Auto] (
) , [Creative Shot] (
), [Auto] (
), [High-speed Burst] (
), [Low Light] (
), [Fireworks] (
)
) , [Creative Shot] (), [Auto] (), [High-speed Burst] (), [Low Light] (), [Fireworks] ()1. Press the power button to turn the camera on.
2. Press the [Flash] (
) button.
) button.
3. Press the [ 
], [ 
] buttons to choose [On] (
).
], [ ] buttons to choose [On] ().
4. The option you configured is now displayed.
